Entrapped Air Removal; Final Decal Squeegee - Mercury 25 EFI Service Manual

7. Lightly hinge the other half of the decal to expose the liner tape and remove the liner paper.
8. Apply a little tension to the decal and squeegee the entire decal from the center towards the outside edge with overlapping
strokes. Be sure to overlap the outside edge of the decal with the squeegee.
9. Inspect the decal closely for entrapped air bubbles. Use the squeegee to push the air bubble to the outside edge.
10. Remove the premask liner from the decal beginning at one corner and carefully pull the premask liner off and onto itself at
a 180° angle.
IMPORTANT: When the premask is removed from the decal, the pulling force loosens the adhesive at the edges of the
decal. It is imperative to squeegee the entire decal with special attention to the edges of the decal.
11. Do not allow the premask to remain on the decal for more than 24 hours after installation.
12. Squeegee the complete decal including all edges after the premask liner has been removed.

Entrapped Air Removal

The micro‑comply adhesive has a unique pattern to the adhesive that allows entrapped air to escape through very small
channels for a faster, easier installation. Always work from the center of the decal towards the edge. If the channels are closed
off, use an air release tool or straight pin to aid in removing the bubble. Puncture one end of the bubble and use your thumb to
push the entrapped air towards the puncture site. Do not use a knife or razor blade to puncture the decal.

Final Decal Squeegee

It is recommended to use a Meguiar's Supreme Shine Microfiber Towel for the final decal squeegee. With a firm hand pressure,
work the decal from the center out to the edge. Ensure to pay attention to the edge of the decal during this final decal
squeegee.
IMPORTANT: It is imperative to squeegee the entire decal with special attention to the edges of the decal.
IMPORTANT: Do not allow the new decal to have direct sunlight contact for a minimum of 24 hours.
90-8M0105568 eng MARCH 2016
50338
© 2016 Mercury Marine
General Information
Page 1C-17