Upper Motor Mount Replacement; Removal - Power Trim Models; Removal - All Models - Mercury 25 EFI Service Manual

Upper Motor Mount Replacement

Removal ‑ Power Trim Models
1. Remove the electrical plate cover and disconnect the power trim wires from the solenoids.
2. Remove the two harness clamps securing the power trim wire harness to the clamp bracket and pull the wire harness
through the clamp bracket.
c
b
a
Removal ‑ All Models
1.
Remove the driveshaft housing cover. Refer to Driveshaft Housing Cover, preceding.
2.
Remove the lower cowl cover. Refer to Section 7B.
3. On tiller handle models, remove the throttle only assembly. Refer to Section 7A.
4. Remove the upper shift shaft from the horizontal shift lever shaft. Refer to Section 7A.
5.
Remove the flywheel cover and flywheel. Refer to Section 2A.
90-8M0105568 eng MARCH 2016
a
b
a - Port clamp bracket
b - Tilt tube port side nut
c - Power trim harness
d - Harness clamps (2)
d
e - Tilt pin and cotter pin
f - Lower pivot pin, bushing, washer, and snap ring
e
f
19142
Clamp/Swivel Bracket, Driveshaft Housing
a - Green heavy gauge pump wire/green
relay terminal (down)
b - Blue heavy gauge pump wire/blue relay
terminal (up)
20926
© 2016 Mercury Marine Page 5A-21