Clamp Bracket Installation - Mercury 25 EFI Service Manual

4. Install the plate over the pivot shaft.
5. Secure the plate and tilt stop bracket with two bolts. Tighten bolt to specified torque.
d
Description
Tilt stop bolts

Clamp Bracket Installation

1. Install the two bushings in the swivel bracket.
2. Install the port clamp bracket and tilt tube through the swivel bracket.
IMPORTANT: The tilt tube end with fewer threads is assembled to the starboard clamp bracket.
3. Ensure that the tilt stop bracket pin is positioned between the stops on the reverse lock lever.
4. Position the tilt end of stop bracket in the clamp bracket tilt slot.
90-8M0105568 eng MARCH 2016
c
Clamp/Swivel Bracket, Driveshaft Housing
a
b
20850
© 2016 Mercury Marine
a - Bolts (2)
b - Plate
c - Tilt stop bracket pin
d - Reverse lock lever stops
Nm lb. in.
27
lb. ft.
20
Page 5A-47