Shift Link Rod Removal And Installation (Tiller Models); Shift Cam Adjustment (Tiller Models) - Mercury 25 EFI Service Manual

Jet Drive Outboard
4. Install the access cover with three bolts. Tighten the bolts to the specified torque.
b
Description
Access cover mounting bolts

Shift Link Rod Removal and Installation (Tiller Models)

Remove and install the shift rod, as shown.
a
b
c
d
a
b
c

Shift Cam Adjustment (Tiller Models)

If not properly installed, the reverse gate can interfere with water coming off the rudder, suddenly and unexpectedly slowing
the boat. This can cause serious injury or death from occupants being thrown within or out of the boat. Adjust the shift cable
to prevent the reverse gate from interfering with water flow off the rudder.
Page 9A-22
b
25871
b
WARNING
!
© 2016 Mercury Marine
a - Mountings bolts
b - Access cover
a
Nm
a - Clip
b - Flat washer
c - Spring
d - Shift link rod
25884
90-8M0105568 eng MARCH 2016
lb. in. lb. ft.
10 88.5