Mercury 25 EFI Service Manual page 69

4. Loosen the bolt securing the control harness retainer bracket.
b
a
5. Remove the bolt securing the cable barrel retainer to the cowl.
6. Connect the remote harness to the engine harness connector.
7. Route the harness below the shift actuating lever pin.
8. Route the harness between the barrel support.
a
9. Ensure the harness retainer bracket is over the remote harness. Secure harness retainer bracket with bolt. Tighten bolt to
the specified torque.
10. Install the shift link to the shift actuating lever.
a
90-8M0105568 eng MARCH 2016
c
d
c
b
b
c
a -
b -
c -
d -
e -
e
10114
d
10128
a -
d
b -
c -
d -
10135
© 2016 Mercury Marine
Outboard Installation
Shift link, cotter pin retainer, and washer
Shift actuating lever, cotter pin retainer, and
washer
Throttle actuating lever, cotter pin retainer,
and washer
Shift link
Bolt securing harness retainer bracket
10127
a - Harness connector
b - Shift actuating lever pin
c - Harness retainer bracket
d - Barrel support
Washer and cotter pin retainer securing shift link
Shift actuating lever
Harness retainer bracket bolt
Shift link
Page 1D-15