Mercury 25 EFI Service Manual page 465

5. Install a washer and nut. Tighten the nut to the specified torque.
Description
Nut
Installation
1. Place the shift detent in the shift detent bracket.
2. Apply 2‑4‑C with PTFE to the shift detent.
a
Tube Ref No.
2-4-C with PTFE
95
3. Position the shift lever shaft with reference to the shift detent as shown.
NOTE: The illustration is for reference to show alignment of the shift lever shaft and the shift detent.
90-8M0105568 eng MARCH 2016
a -
a
b -
b
18738
Description
Washer and nut
Throttle only components
a - Shift detent
b - Shift detent bracket
b
18835
Where Used
Shift detent
© 2016 Mercury Marine
Throttle/Shift Linkage
Nm lb. in. lb. ft.
6 53
Part No.
92-802859A 1
Page 7A-13