Swivel Bracket - Disassembly And Reassembly - Mercury 25 EFI Service Manual

Clamp/Swivel Bracket, Driveshaft Housing
Swivel Bracket ‑ Disassembly and Reassembly
Disassembly
1. Extend the power trim cylinder to the tilt position.
2. Engage the tilt lock lever.
3. Remove the rubber damper from the bottom yoke.
4. Remove the ground cable bolt from the bottom yoke.
5. Remove the snap ring from the steering shaft assembly.
6. Use a torch lamp to warm the bottom yoke.
7. Use a dead blow hammer to remove the bottom yoke from the steering shaft assembly.
c
Torch Lamp
8. Wait until the steering shaft is cool.
9. Remove the washer, O‑ring, and bushing from the steering shaft.
Page 5A-36
e
a
b
© 2016 Mercury Marine
a -
a
b -
c -
d -
e -
b
c
d
19373
Rubber damper
Bottom yoke
Ground cable bolt
Steering shaft assembly
Snap ring
a - Torch lamp
b - Dead blow hammer
c - Bottom yoke
19379
91‑63209
90-8M0105568 eng MARCH 2016