Entrapped Air Removal; Final Decal Squeegee; Cleaning And Maintenance; General Cleaning Instruction - Mercury FourStroke 2.5 Service Manual

General Information
IMPORTANT: When the premask is removed from the decal, the pulling force loosens the adhesive at the edges of the
decal. It is imperative to squeegee the entire decal with special attention to the edges of the decal.
11. Do not allow the premask to remain on the decal for more than 24 hours after installation.
12. Squeegee the complete decal including all edges after the premask liner has been removed.

Entrapped Air Removal

The micro‑comply adhesive has a unique pattern to the adhesive that allows entrapped air to escape through very small
channels for a faster, easier installation. Always work from the center of the decal towards the edge. If the channels are closed
off, use an air release tool or straight pin to aid in removing the bubble. Puncture one end of the bubble and use your thumb to
push the entrapped air towards the puncture site. Do not use a knife or razor blade to puncture the decal.

Final Decal Squeegee

It is recommended to use a Meguiar's Supreme Shine Microfiber Towel for the final decal squeegee. With a firm hand pressure,
work the decal from the center out to the edge. Ensure to pay attention to the edge of the decal during this final decal
squeegee.
IMPORTANT: It is imperative to squeegee the entire decal with special attention to the edges of the decal.
IMPORTANT: Do not allow the new decal to have direct sunlight contact for a minimum of 24 hours.

Cleaning and Maintenance

IMPORTANT: Never use petroleum products or strong household cleaning chemicals to clean the outside surface of the cowls.
Using petroleum products or strong household cleaning chemicals will cause damage to the decal and may damage the cowl.
IMPORTANT: Pressure wash and scrub brush with caution. Always use a wide spray pattern, low‑pressure, and an angle less
than 60° to the surface when using a pressure washer. Low angle water streams can lift the decal from the surface.

General Cleaning Instruction

• Rinse the surface well with lukewarm water to remove dirt.
• Use a soft cloth or sponge to gently wash the surface with a mild dishwashing soap with lukewarm water.
• Do not scrub, use a brush, or a squeegee.
• Rinse the surface thoroughly.
• Use a clean, soft, lint‑free cloth to dry and prevent water spotting.
Page 1C-12
50338
90-8M0065421 NOVEMBER 2012