Throttle Only Reassembly And Installation - Mercury 25 EFI Service Manual

3. Remove the gear components from the outer gear plate.
a
b
4. Inspect all components for cracks and wear. Replace as required.

Throttle Only Reassembly and Installation

Reassembly
1. Install the spring and actuator into the shift lever shaft. While pushing on the actuator, install the retaining pin through the
shaft.
a
a - Actuator
b - Spring
c - Pin
d - Shift lever shaft
90-8M0105568 eng MARCH 2016
c
d
e
f
m
b
c
g
h
i
j
d
© 2016 Mercury Marine
Throttle/Shift Linkage
a - Drive gear bolt
b - Bushing
c - Throttle opener
d - Washer
e - Drive gear pulley
f - Gear plate
g - Drive gear
h - Bushing
i - Washer
k
j - Nut
k - Gear plate
l - Bolt
m - Driven gear
l
18425
11902
Page 7A-11