39. Connect the engine harness connector to the MAP sensor.
d
c
b
a
40. Connect the fuel injector harness connectors to the three fuel injectors.
a
41. Insert the electrical cover into the grommets on the intake manifold.
42. Secure the electrical cover with two bolts, washers, and spacers. Tighten the bolts to the specified torque.
43. Install the recoil assembly and the timing belt cover. Refer to Section 8A ‑ Manual Starter.
a
Description
Bolts (2)
90-8M0105568 eng MARCH 2016
f
a -
Fuel injector harness connectors
b -
ECM
b
10451
a -
Grommets in the intake manifold
b -
Bolts securing the wire cover (2)
b
10493
© 2016 Mercury Marine
Charging and Starting System
e
a -
Ignition charge harness
connector
b -
Trigger connector
c -
Fuse holder
d -
Voltage regulator stator
connector
e -
Voltage regulator
sensing lead connector
f -
MAP sensor harness
connector
10456
Nm
lb. in.
6
53
Page 2B-29
lb. ft.