Reverse Lock Hook - Mercury 25 EFI Service Manual

Clamp/Swivel Bracket, Driveshaft Housing
5. Remove the starboard clamp bracket from the tilt tube.
c
6. Remove the bolt securing the port tilt stop. The assembly includes a flat washer between the tilt stop and the clamp
bracket.
7. Remove the port clamp bracket and tilt tube from the swivel bracket.
8. Remove the two bushings in the swivel bracket.
c
e

Reverse Lock Hook

Removal
1. Pry the bushing open and remove the reverse lock link from the bushing and reverse lock hook.
Page 5A-42
a
a - Tilt tube locknut
b - Clamp bracket stud
c - Tilt stop pin
b
20851
a
b
© 2016 Mercury Marine
c
d
20852
90-8M0105568 eng MARCH 2016
a - Tilt stop
b - Bolt and washer
c - Tilt bushing
d - Port clamp bracket
e - Tilt tube