Starter Motor Installation - Mercury 25 EFI Service Manual

Charging and Starting System
Tube Ref No.
SAE Engine Oil 30W
80
15. Ensure the lockwasher and washer are installed onto the starter assembly bolts.
16. Install two starter assembly bolts. Tighten the bolts to the specified torque.
Description
Starter assembly bolt
17. Lubricate the armature shaft and helix with SAE Engine Oil 30W.
Tube Ref No.
SAE Engine Oil 30W
80
18. Install the starter bendix, bendix spring, and pinion stopper. Secure the starter bendix assembly with a circlip. Push the
pinion stopper up to capture the circlip.

Starter Motor Installation

1. Install the starter to the cylinder block. Secure the starter with two bolts and washers. Ensure the rubber mount is properly
centered where it contacts the cylinder block. Tighten the bolts to the specified torque.
2. Install one of the starter brace bolts into the cylinder block. Do not tighten the bolt.
Page 2B-44
Description
Description
a
© 2016 Mercury Marine
Where Used
Armature shaft
10502
10541
Where Used
Starter armature shaft, and helix
a - Bendix
b
b - Bendix spring
c
c - Pinion stopper
d
d - Circlip
22261
Part No.
Obtain Locally
Nm lb. in.
6 53
Part No.
Obtain Locally
90-8M0105568 eng MARCH 2016
lb. ft.