Swivel Bracket/Clamp Bracket Removal - Mercury 25 EFI Service Manual

9. Install the starboard side tilt tube locknut.
c
10. install the outboard on the transom.

Swivel Bracket/Clamp Bracket Removal

Shift Control Removal - Remote Control Models
1. Remove the two bolts securing the bottom cowl cover and remove the cover.
2. Remove the bolt securing the remote control cable clamp bracket.
3. Remove the cotter pins and washers on the remote control throttle and shift cables.
4. Remove the cotter pins and washers on the shift rod.
5. Remove the shift rod, throttle cable, and shift cable.
6. Loosen the bolts securing the remote control bracket approximately 6 mm (1/4 in.).
7. Slide the shift lever shaft out from the shift lever shaft bracket and remove the upper shift shaft. Refer to Section 7A ‑
Remote Control Models ‑ Shift Control Removal.
Shift Control Removal - Tiller Handle Models
1. Remove the bottom cowl upper clamp. Remove the shift/throttle cables and the throttle link. Refer to Section 7B ‑ Tiller
Handle Removal.
2. Remove the two throttle rods from the throttle lever. Refer to Section 7B ‑ Tiller Handle Removal.
3. Remove the throttle only button retainer clip from the cowl.
4. Remove the retainer, grommet and throttle only button.
5. Remove the three screws securing throttle only assembly to the engine block.
6. Remove the upper shift shaft from the shift lever. Refer to Section 7A ‑ Throttle Only Removal.
Removal
1. Remove the flywheel cover and flywheel. Refer to Section 2A ‑ Flywheel Removal.
2. Attach a chain hoist hook to the powerhead lift eye.
90-8M0105568 eng MARCH 2016
a
a - Tilt tube locknut
b - Clamp bracket stud
c - Tilt stop pin
b
20851
© 2016 Mercury Marine
Clamp/Swivel Bracket, Driveshaft Housing
Page 5A-49