Stop Wire Connections; Throttle Cables - Mercury 25 EFI Service Manual

Tiller Handle

Stop Wire Connections

1. Connect the lanyard switch black/yellow and black wire bullet connectors to the black/yellow and black stop switch bullet
connectors.
2. Connect the loose black wire bullet connector (from the lanyard stop switch) to the black wire bullet connector.
3. Connect the loose black/yellow wire bullet connector (from the lanyard stop switch) to the brown wire bullet connector.

Throttle Cables

1. Rotate the tiller twist grip to the neutral position.
2. Install the reverse throttle cable end in the reverse cable slot in the pulley.
3. Wrap the cable in the inner groove around the top side of the pulley.
a
4. Rotate the tiller twist grip counterclockwise until the reverse cable slot in the pulley is near the top.
5. Install the forward cable end in the forward cable slot in the pulley.
Page 7B-22
b
c
a
e
f
b
© 2016 Mercury Marine
a -
b -
c -
d -
e -
f -
d
18096
18144
Black (lanyard stop switch)
Black/yellow (tiller handle stop button)
Brown (engine harness)
Black (engine harness)
Black/yellow (lanyard stop switch)
Black (tiller handle stop button)
a - Reverse cable
b - Reverse cable slot
90-8M0105568 eng MARCH 2016