Jet Drive Reassembly; Bearing Carrier Installation - Mercury 25 EFI Service Manual

2. Remove the liner. If the liner is tight, tap on the inner edge of the liner with a long drift punch through the intake grate.

Jet Drive Reassembly

Bearing Carrier Installation

NOTE: Individual bearing carrier components are not sold separately. The bearing carrier must be serviced as an assembly.
1. Ensure the three O‑ring seals are in place.
a
2. Place the bearing carrier into the jet drive and fasten with two screws. Apply Loctite 271 to the screw threads and tighten
the screws to the specified torque.
b
Tube Ref No.
Loctite 271 Threadlocker
7
Description
Bearing carrier mounting screws
90-8M0105568 eng MARCH 2016
25787
Description
a
a - Liner
b - Mounting bolt (2)
b
a - O‑ring seals
a
25829
a - Screws
b - Bearing carrier
a
25763
Where Used
Bearing carrier mounting screw threads
© 2016 Mercury Marine
Jet Drive Outboard
Part No.
92-809819
Nm lb. in. lb. ft.
3.4 30
Page 9A-15