Mercury 25 EFI Service Manual page 129

5. Tighten the bolts to the specified torque.
a
Description
Voltage regulator/rectifier bolt (2)
6. Guide the voltage regulator/rectifier sensing lead connector and the stator connector behind the fuse wires and the engine
wire harness.
7. Connect the voltage regulator/rectifier sensing lead connector to the engine harness connector. Secure the voltage
regulator/rectifier sensing lead connector to the engine harness with two cable ties.
b
a
8. Connect the voltage regulator/rectifier stator connector to the stator connector. Secure the voltage regulator/rectifier stator
connector to the engine harness with a cable tie.
90-8M0105568 eng MARCH 2016
a - Voltage regulator/rectifier ground wire
b
b - Bolts securing the voltage regulator/rectifier (2)
20823
c
20829
a - MAP sensor
b - Voltage regulator/rectifier connector
c - Cable ties securing the voltage regulator/
rectifier sensing lead connector (2)
20822
© 2016 Mercury Marine
Charging and Starting System
Nm lb. in. lb. ft.
6 53
Page 2B-17