Clamp Bracket/Swivel Bracket - Manual Tilt Models; Clamp Bracket Removal - Mercury 25 EFI Service Manual

11. Install the flywheel and flywheel cover. Refer to Section 2A ‑ Flywheel Installation.
Shift Control Installation - Remote Control Models
1. Install the upper shift shaft to the shift lever.
2. Push the shift lever shaft into the shift lever shaft bracket.
3. Tighten the bolts securing the remote control bracket.
Description
Remote control bracket bolts
4. Install the shift rod, throttle cable, and shift cable.
5. Install the cotter pins and washers on the shift rod.
6. Install the cotter pins and washers on the remote control throttle and shift cables.
7. Install the bolt securing the remote control cable clamp bracket. Refer to Section 7A ‑ Remote Control Models ‑ Shift
Control Assembly and Installation.
8. Install the bottom cowl cover and secure with two bolts.
Power Trim Models
1. Pull the wire harness through the bottom cowl.
2. Connect the power trim wires to the solenoids and install the electrical plate cover.
Shift Control Installation - Tiller Handle Models
1. Install the upper shift shaft into the shift lever.
2. Install the throttle only assembly to the shift lever shaft.
3. Attach the throttle only assembly to the powerhead with three bolts. Tighten the bolts to specified torque.
4. Install the throttle only button, grommet, and retainer.
5. Install the throttle only retaining clip. Refer to Section 7A ‑ Throttle Only Reassembly and Installation.
Description
Throttle only attaching bolts (3)
6. Install the throttle link to the throttle lever. Refer to Section 7B ‑ Tiller Handle.
7. Install the throttle cables to the throttle only pulley. Refer to Section 7B ‑ Tiller Handle.
8. Install the grommet and bottom cowl upper clamp. Refer to Section 7B ‑ Tiller Handle.
Clamp Bracket/Swivel Bracket ‑ Manual Tilt Models

Clamp Bracket Removal

NOTE: If only one clamp bracket is being removed, the outboard may remain on the transom.
1. Loosen the clamp screws.
2. Remove the outboard from the transom.
3. Remove the tilt stop pin and clamp bracket stud.
4. Remove the starboard side tilt tube locknut.
90-8M0105568 eng MARCH 2016
Clamp/Swivel Bracket, Driveshaft Housing
© 2016 Mercury Marine
Nm lb. in. lb. ft.
6 53
Nm lb. in. lb. ft.
6 53
Page 5A-41