Mercury 25 EFI Service Manual page 337

12. Connect the blue and green power trim wires to the solenoids.
13. Attach the electrical plate cover with two bolts. Tighten the bolts to specified torque.
Description
Electrical plate cover bolts
14. Attach the ground cable to the anode and attach the anode to the clamp brackets with two bolts. Tighten the bolts to
specified torque.
Description
Anode bolts
15. Reinstall the transom bolts through the port clamp bracket.
g
d
Starboard Clamp Bracket Removal
1. Remove the two bolts securing the anode to the clamp brackets.
2. Remove the transom bolts from the starboard clamp bracket.
g
d
3. Loosen the tilt tube nut from the port side.
90-8M0105568 eng MARCH 2016
a
e
g
b
a
e
g
b
a
Clamp/Swivel Bracket, Driveshaft Housing
b
a -
b -
20926
g
f
c
g
f
c
© 2016 Mercury Marine
Green heavy gauge pump wire/green
relay terminal (down)
Blue heavy gauge pump wire/blue relay
terminal (up)
Nm lb. in.
6 53
Nm lb. in.
6 53
a - Bolt and ground cable
b - Anode
c - Bolt
d - Port clamp bracket
e - Lower pivot pin
f - Starboard clamp bracket
g - Bushing
19141
a - Bolt and ground cable
b - Anode
c - Bolt
d - Port clamp bracket
e - Lower pivot pin
f - Starboard clamp bracket
g - Bushing
19141
lb. ft.
lb. ft.
Page 5A-31