Exposure Lamp Replacement - Ricoh FT6645 Manual

23 April 1993

2.2 EXPOSURE LAMP REPLACEMENT

[E]
[B]
NOTE: Do not touch the reflector or the new exposure lamp with your
bare hands. Use a strip of paper as shown. (Oil marks from
fingers on the lamp or reflectors will be affected by heat from the
lamp.)
1. Remove the exposure glass. (Refer to Exposure Glass Removal.)
2. Move the first scanner [A] to the cutout position at the rear frame [B].
(See illustration.)
3. Remove the reflector cover [C] (2 screws).
4. While holding the lamp with the paper strip, release the lamp terminal [D]
as shown; then, take out the lamp.
5. Install a new lamp. Use a strip of paper as shown to hold the lamp.
Confirm that the lamp is properly set by both terminals and that the clip
[E] is set properly.
[C]
[A]
5-11
OPTICS
[D]