23 April 1993
7.4 FUSING LAMP REPLACEMENT
[D]
[B]
[F]
1. Remove the fusing unit. (Refer to Fusing Unit Removal.)
2. Remove the terminal bracket [A] (2 screws).
3. Disconnect the front connector [B] and the rear connector [C].
4. Remove the front fusing lamp holder [D] and the rear fusing lamp holder
[E] (1 screw each).
5. Replace the fusing lamp [F].
NOTE: Locate the yellow connector [C] of the fusing lamp to the rear
side.
Set the connectors from the fusing lamp (yellow) [G] and from the
thermofuse (white) [H] in the correct position on the terminal.
[E]
5-99
FUSING UNIT
[C]
[G]
[H]
[A]