Ricoh FT6645 Manual page 317

PAPER FEED
[B]
[C]
4. Re-install both side fences [A] to the appropriate position according to the
paper size, as shown.
NOTE: The position of the side fence holders [B] and the pins [C] on the
lack gear differs according the paper size (from the outside pin:
A4, 11", B5).
5. Change the position of the front and rear side fences [D] (2 screws each)
and end fence [E] (2 screws) on the left tandem tray according to the
paper size.
6. Enter SP mode (refer to Service Program Access Procedure) and access
SP Special Features – PAGE 5.
4
7. Select the appropriate paper size according to position of the side and
end fences.
[A]
[A]
5-92
[E]
23 April 1993
[D]