Ricoh FT6645 Manual page 253

OPTICS
[B]
[D]
13. Route the longer end [A] of the front scanner drive wire in the following
order.
Through rear track, upper side.
Counterclockwise.
Upper track clockwise.
Hook the end of the wire [A] on the cut out on the right optics side
frame.
14. Slightly push the front drive pulley [B] against the front optics side frame
and tighten the two Allen screws.
15. Remove the jig pins securing the second scanner.
16. Remove the tapes [C] fixing the ends of the scanner drive wires and hook
the ends of the scanner drive wires with the tension springs.
17. Remove the tapes [D] fixing the wire to the front and rear drive pulleys.
[C]
5-28
23 April 1993
[A]