Ricoh FT6645 Manual page 29

PROCESS CONTROL
1.2 PROCESS CONTROL DATA INITIAL SETTING
The following flow chart shows all the steps that will be performed whenever
the machine is turned on while the hot roller temperature is below 100°C.
This initializes all the process control settings.
Main SW On (Fusing Temp. < 100°C)
Charge wire cleaning (if more than 5 K copies are made since
last cleaning
Drum Potential Sensor Calibration
Drum Conditioning Start (Fusing Temp. = 180°C)
V Adjustment
SG
V Measurement
R
V /V Correction
D L
TD Sensor Detection
ID Sensor Detection/Correction
ADS Adjustment
: See Latent Image Control section (Page 2-5) for details.
: See Image Density Control section (Page 2-12) for details.
: See Optics section (Page 2-39) for details.
2-4
23 April 1993