23 April 1993
6.6 PAPER FEED TIMING ADJUSTMENT
[B]
10 mm
[D]
10 ± 5 mm
1) Paper feed timing adjustment for the 1st feed station
1. Place a white paper on the exposure glass so that there is a gap of 10
mm between the white paper [A] and the left scale [B].
2. Enter SP mode (refer to Service Program Access Procedure) and access
the
SP Adjustment – PAGE 2.
1
3. Touch the "Copy in SP" key [C] then select the 1st feed station.
4. Enter a copy quantity of "2" using the number keys.
5. Touch the "SP Mode" key.
6. Press the Start key and evaluate the width of the white area [D] on the
copy. The adjustment standard is 10 ± 5 mm.
NOTE: In this mode, the registration roller does not stop for registration.
Do not make copies in "Copy in SP" mode for this adjustment. In
"Copy in SP" mode, the registration clutch stops normally.
[C]
[A]
5-73
PAPER FEED