Ricoh FT6645 Manual page 171

23 April 1993
2 SP TEST MODE
PAGE 3
Item
Use to check if the original size sensors
are correctly activated and de-activated.
Use to check if the sensors or switches
are correctly activated and de-activated.
Access this mode as follows:
1. Touch the input mode key
2. Enter the sensor/switch/signal
number by using the number keys on
the operation panel. (Refer to the
input check mode on page 4-35)
3. Touch the enter key
Use to confirm the proper function of
the copier electrical components
Access this mode as follows:
1. Touch the Output mode key
2. Enter the electrical component
number by using the number keys on
the operation panel (Refer to the
output check mode on page 4-41).
3. Press the enter key
Operates the DF without the copier
operation.
Operates the sorter stapler (A374 and
A377) or A379 finisher without copier
operation.
Function
.
.
.
.
4-17
SERVICE PROGRAM MODE
PAGE 4
Note
Status 0 ----- de-activated
Status 1 ----- activated
Status 0 ----- de-activated
Status 1 ----- activated
This mode cannot be used with the
MATT20
ON
Touch to activate and touch
OFF
to de-activate the electrical
component
This mode cannot be used with the
MATT20
Procedure:
1. Set originals on the table.
Start
2. Touch .
The sorter operates as if 3 copies are
made from five originals in sort and
staple mode. No stapling is actually
made.