Ricoh FT6645 Manual page 165

23 April 1993
1 SP ADJUSTMENT
PAGE 5
Item
Adjusts the lens position to correct
magnification in enlarge/reduction
modes.
Adjusts the 3rd scanner home position
to correct the focus.
Factory use only
Adjusts the ADS sensor output while
scanning the ADS pattern to 2.7 ± 0.1 V
Adjusts the VSG to 4.0 ± 0.2 V.
Adjusts the original stop position
against the original side scale in
one-sided original mode (0.5 mm/step).
Adjusts the original stop position
against the original side scale in
two-sided original mode (0.5 mm/step).
Function
4-11
SERVICE PROGRAM MODE
PAGE 6
Input only the data number marked on
the lens.
Do not change the data.
This mode is also performed during the
process control data initial setting.
This mode is also performed during the
process control data initial setting.
Refer to page 43 of the DJF manual.
Refer to page 44 of the DJF manual.
Note