Ricoh FT6645 Manual page 287

TRANSFER BELT UNIT
[C]
[A]
2. Install the transfer belt unit prop (3 screws).
NOTE: To install the transfer belt unit prop smoothly, set in order the
lower pins [A], drive roller shaft [B], and the upper pins [C].
3. After installation, confirm the following points:
1) Smooth up-down movement of the transfer belt unit,
2) Part [D] of the transfer belt unit is inside the drum stay,
3) Part [D] of the transfer belt unit is set in the dent [E] on the drum unit
casing.
[B]
5-62
23 April 1993
[E]
[D]