Ricoh FT6645 Manual page 272

23 April 1993
3.5 TONER BOTTLE DRIVE MOTOR REPLACEMENT
[D]
[E]
[B]
[F]
1. Open the toner bottle holder [A] with the bracket [B]. (Refer to
Development Unit Removal.)
2. Remove the toner bottle [C].
3. Remove four screws then remove the toner bottle holder by unhooking
the hole [D] from the pin on the hinge.
4. Remove the toner receiver [E].
5. Remove the toner bottle drive motor assembly [F] (1 connector, 2 screws).
6. Remove an E-ring [G] and slide the gear [H] to access a screw.
7. Replace the toner bottle drive motor [I] (3 screws – M3 x 4).
DEVELOPMENT AND TONER SUPPLY
[A]
[I]
5-47
[C]
[G]
[H]