Ricoh FT6645 Manual page 123

IMAGE FUSING 23 April 1993
7.5 INVERTER AND PAPER EXIT
[D] [B]
[A]
[C]
[F]
[H]
[E]
[F]
[G]
After passing the fusing unit, copies enter the inverter unit where paper is
distributed to the paper exit rollers [A] or the duplex unit.
The junction gate solenoid changes the position of the junction gate [B]. In
duplex mode, the junction gate solenoid turns on to raise the junction gate so
that the junction gate guides the paper into the duplex unit.
The fusing exit sensor [C] and exit sensor [D] monitor paper misfeeds.
The duplex transport sensor [E] is used not only to monitor paper misfeed
detection, but also to activate the duplex jogger motor.
When the paper passes the duplex transport roller [F], the paper pushes the
paper guide [G] up, and the actuator on the rear end of the paper guide shaft
de-activates the paper guide sensor [H]. The duplex entrance sensor
monitors paper misfeeds.
2-98