Tandem Rear Fence Drive Belt Removal - Ricoh FT6645 Manual

PAPER FEED

6.4 TANDEM REAR FENCE DRIVE BELT REMOVAL

(A096 copier only)
[E]
1. Draw out the tandem tray.
2. Separate the right tandem tray from the left tandem tray [A]. (Refer to
Tandem Tray Removal.)
3. Remove the rear fence [B] on the left tandem tray (2 screws).
4. Remove the rear base plate [C] with the rear fence drive motor [D] (3
screws).
NOTE: When re-installing the rear base plate, make sure that the
grounding plate [E] is attacked to the rear base plate.
5. Remove the end fence [F] (2 screws).
6. Remove the center bottom plate [G] (2 screws).
[D]
[C]
[F]
5-70
23 April 1993
[B]
[C]
[A]
[G]