23 April 1993
7.7 FUSING STRIPPER PAWL REPLACEMENT
1. Turn off the main switch and pull out the fusing unit.
2. Lower the fusing exit assembly [A].
3. Remove the two screws (the front screw [B] is a stepped screw) fixing the
upper exit guide [C].
4. Unhook the spring [D] then replace the strippers [E].
NOTE: After setting the fusing stripper pawl, confirm that the strippers
are correctly held by the stripper holders [F] as shown,
If not, remove the stripper and bend the holders [F] inward.
Apply the grease-Barrierta L55/2 on the inner surface of the
holder [F].
5-103
FUSING UNIT