23 April 1993
5. TRANSFER BELT UNIT
5.1 TRANSFER BELT UNIT REMOVAL/INSTALLATION
[A]
[B]
- Removal -
1. Turn off the main switch.
2. Remove the transfer belt unit prop [A] (3 screws).
3. Disconnect the connector [B].
4. While turning the lever [C] counterclockwise, take out the transfer belt unit.
NOTE: 1) Do not touch the transfer belt with oily hands.
2) Take care not to scratch the OPC drum with part of the
transfer belt unit. Be careful when installing the transfer belt
unit.
- Installation -
1. While turning the lever [C] counterclockwise, install the transfer belt unit.
NOTE: 1) Insert the gear [D] in the hole [E] on the rear frame.
2) Place the slot [F] of the transfer belt unit on the rail [G].
[F]
[G]
[C]
5-61
TRANSFER BELT UNIT
[D]
[E]