Ricoh FT6645 Manual page 255

OPTICS
[C]
[D]
20. Place the first scanner unit on the guide rail then adjust the first scanner
alignment as follows:
- First Scanner Alignment -
1) Move the first scanner [A] to the left end position. Fix the rear end of
the first scanner by inserting the jig pin [B] in the holes on the first
scanner and the guide rail.
2) Position the first scanner so that the jig pin [C] can be smoothly set in
the holes on the first scanner and the guide rail, then tighten the wire
clamp brackets [D] (4 screws).
21. Install the scanner HP sensor [E] (1 screw).
22. Secure the scanner flat cable (1 screw).
23. Install the upper optics frame [F] (9 screws).
[E]
[B]
[D]
[A]
5-30
23 April 1993
[F]