Ricoh FT6645 Manual page 177

23 April 1993
PAGE 2
Item Function
Enables user code mode.
* See the NOTE below.
Enables the PM alarm.
Selects the PM alarm
interval after counter clear
( PM Counter Clear -
9
PAGE 1)
NOTE: To enable user code mode, perform the following procedure.
CAUTION: When
entered.
1. Register the user code by using user tool No.6.
2. Enter SP mode then enable the user code mode by selecting
3. Turn off the main switch.
4. Remove the plastic cap [A] on the right upper cover.
5. Disconnect the key counter short-circuit connector [B].
6. Return the plastic cap [A].
7. Turn on the main switch and check the operation.
Set
Reset
Set
Reset
is selected, at least one user code should be
Set
4-23
SERVICE PROGRAM MODE
Setting
Enable
Disable
Enable
Disable
[B]
[A]
Default
Reset
Reset
120 K
.
Set