Configuring Basic Settings; Srx210 Services Gateway Software Configuration Overview; Preparing The Srx210 Services Gateway For Configuration - Juniper SRX210 Series Manual

CHAPTER 17

Configuring Basic Settings

SRX210 Services Gateway Software Configuration Overview

Preparing the SRX210 Services Gateway for Configuration

Copyright © 2012, Juniper Networks, Inc.
SRX210 Services Gateway Software Configuration Overview on page 125
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
CLI on page 129
Performing Initial Software Configuration on the SRX210 Services Gateway Using the
J-Web Interface on page 131
This topic includes the following sections:
Preparing the SRX210 Services Gateway for Configuration on page 125
Understanding the Factory Default Configuration on page 126
Understanding Built-In Ethernet Ports and Initial Configuration on page 126
Mapping the Chassis Cluster Ports on page 127
Understanding Management Access on page 127
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled and ready to be configured when the device is powered on.
You can perform the initial software configuration of the services gateway by using the
browser-based setup wizard or by using the command-line interface (CLI).
Before configuring the device, gather the configuration information required to deploy
the device in your network. At minimum, the setup wizard requires the following
information:
Device name to be used on the network
Password for the root user
Time information for services gateway location:
Local time zone
Name or IP address of a Network Time Protocol (NTP) server, if NTP is used to set
the time on the services gateway
125