Figure 16: Srx210 Services Gateway Installation In A Rack - Positioning Mounting; Table 34: Srx210 Services Gateway Rack Installation Parts - Juniper SRX210 Series Manual

SRX210 Services Gateway Hardware
96
NOTE:
If you are installing multiple devices in one rack, install the lowest one first
and proceed upward in the rack.
Ensure that the rubber feet from the base of the chassis are removed for
rack installation.
To install the device in a rack:
Position a mounting bracket on each side of the chassis as shown in
1.
page 96.
Figure 16: SRX210 Services Gateway Installation in a Rack — Positioning
Mounting Brackets
Table 34 on page 96 lists the parts used for installing the SRX210 Services Gateway
on the rack. The numbers in
34 on page 96.

Table 34: SRX210 Services Gateway Rack Installation Parts

Number Part
1 Mounting brackets
2 Screws (mounting bracket)
3 Power supply adapter tray
4 Adapter stopper bracket
Use a number-1 Phillips screwdriver to install the screws that secure the mounting
2.
brackets and power supply adapter tray to the chassis as shown in
Figure 16 on page 96 correspond to the numbers in
Copyright © 2012, Juniper Networks, Inc.
Figure 16 on
Table
Figure 17 on page 97.