Juniper SRX210 Series Manual page 125

Related
Documentation
Copyright © 2012, Juniper Networks, Inc.
Chapter 14: Connecting, Grounding, and Powering On the Services Gateway
transmit data. You must configure each network interface before it can operate on the
device.
To connect and organize an interface cable for the device:
Have ready a length of the type of cable used by the interface.
1.
Insert the cable connector into the cable connector port on the interface faceplate.
2.
Arrange network cables as follows to prevent them from dislodging or developing
3.
stress points:
Secure cables so that they are not supporting their own weight as they hang to the
floor.
Place excess cable out of the way in neatly coiled loops.
Use fasteners to maintain the shape of cable loops.
Connecting the SRX210 Services Gateway to the Power Supply on page 105
Grounding the SRX210 Services Gateway on page 108
Interface Cable and Wire Specifications for the SRX210 Services Gateway on page 71
SRX210 Services Gateway Installation Safety Guidelines and Warnings on page 91
107