SRX210 Services Gateway Hardware
Related
Documentation
86
NOTE:
The SRX210 Services Gateway cannot be center-mounted in racks.
Table 31 on page 86
provides the list of tasks you need to perform before installing the
device.
Table 31: SRX210 Services Gateway Preinstallation Checklist for
Rack-Mount Installation
Task
Verify that the site meets the requirements.
Verify that the racks or cabinets meet the specific
requirements.
Place the rack or cabinet in its permanent location,
allowing adequate clearance for airflow and
maintenance, and secure it to the building structure.
Remove the services gateway chassis from the
shipping carton.
Verify that you have the following parts available
in your rack-mounting kit for the SRX210 Services
Gateway:
Rack-mounting brackets
Mounting screws
Power supply adapter tray with screws
Adapter stopper bracket
Adjust the power supply adapter tray.
NOTE:
The rack-mounting kit is not shipped with the device and must be
ordered separately.
Site Preparation Checklist for the SRX210 Services Gateway on page 37
Clearance Requirements for Airflow and Hardware Maintenance of the SRX210 Services
Gateway on page 41
Unpacking the SRX210 Services Gateway on page 81
Preparing the SRX210 Services Gateway for Rack-Mount, Desk-Mount, and Wall-Mount
Installation on page 85
Preparing the SRX210 Services Gateway for Desk-Mount Installation on page 88
Additional Information
"Site Preparation Checklist for the SRX210
Services Gateway" on page 37
"SRX210 Services Gateway Rack
Requirements" on page 40
"Clearance Requirements for Airflow and
Hardware Maintenance of the SRX210
Services Gateway" on page 41
"Unpacking the SRX210 Services Gateway"
on page 81
"Adjusting the Power Supply Adapter Tray
for the SRX210 Services Gateway for
Rack-Mount Installation" on page 87
Copyright © 2012, Juniper Networks, Inc.