Figure 27: Connecting To The Console Port On An Srx210 Services Gateway - Juniper SRX210 Series Manual

Copyright © 2012, Juniper Networks, Inc.

Figure 27: Connecting to the Console Port on an SRX210 Services Gateway

NOTE: Figure 27 on page 119
device. A remote connection to the services gateway through a modem
requires the cable and connector shown (provided in the services gateway
accessory box), plus a DB-9 male to DB-25 male (or similar) adapter for your
modem, which you must purchase separately.
To connect to the CLI using a local management device through the console port on the
services gateway:
Turn off power to the services gateway.
1.
Turn off power to the management device, such as a PC or laptop computer, that you
2.
are using to access the CLI.
Plug one end of the Ethernet cable supplied with your services gateway into the RJ-45
3.
to DB-9 serial port adapter supplied with your services gateway (see
page 119).
Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management
4.
device (see Figure 27 on page
Connect the other end of the Ethernet cable to the console port on the services
5.
gateway (see Figure 27 on page
Turn on the power to the management device.
6.
Start your asynchronous terminal emulation application (such as Microsoft Windows
7.
HyperTerminal) and select the appropriate
Configure the port settings shown in
8.
Chapter 16: Establishing Basic Connectivity
shows a connection to a local management
119).
119).
COM port to use (for example,
Table 37 on page 120.
Figure 27 on
COM1 ).
119