Connecting The Modem At The Srx210 Services Gateway End; Table 38: Port Settings For Configuring The Modem On The Services Gateway - Juniper SRX210 Series Manual

Connecting the Modem at the SRX210 Services Gateway End

Copyright © 2012, Juniper Networks, Inc.
NOTE: These instructions use Hayes-compatible modem commands to
configure the modem. If your modem is not Hayes-compatible, refer to the
documentation for your modem and enter the equivalent modem commands.
To configure the modem on the services gateway end:
Connect the modem to a PC or laptop computer.
1.
Power on the modem.
2.
From the PC or laptop computer, start your asynchronous terminal emulation
3.
application (such as Microsoft Windows HyperTerminal), and select the
which the modem is connected (for example,
Configure the port settings as shown in
4.
Table 38: Port Settings for Configuring the Modem on the Services
Gateway End
Port Setting
Bits per second
Data bits
Parity
Stop bits
Flow control
In the HyperTerminal window, enter
5.
For more information on the AT commands, see the following guides:
Junos OS Initial Configuration Guide for Security Devices
Junos OS Monitoring and Troubleshooting Guide for Security Devices
An response verifies that the modem can communicate successfully with the
OK
port on the PC or laptop.
Configure the modem to answer a call on the first ring by entering
6.
Configure the modem to accept modem control DTR signals by entering
7.
Disable flow control by entering
8.
Save modem settings by entering
9.
Chapter 16: Establishing Basic Connectivity
).
COM1
Table 38 on page 121.
Value
9600
8
None
1
None
.
AT
AT&K0 .
.
AT&W
port to
COM
COM
ATS0=1 .
.
AT&D1
121