Mapping The Chassis Cluster Ports; Understanding Management Access; Table 40: Mapping The Chassis Cluster Ports On An Srx210 Services - Juniper SRX210 Series Manual

Mapping the Chassis Cluster Ports

Understanding Management Access

Copyright © 2012, Juniper Networks, Inc.
Configuration of a chassis cluster—Perform the initial configuration of the chassis
cluster using a console connection. Before you perform the initial configuration, connect
the built-in Ethernet ports as follows:
Port 0/6—Connect to the out-of-band management network for management of
the device. When you enable chassis clustering as part of configuring the chassis
cluster, the management interface (
Port 0/7—Connect to the other device in the chassis cluster. When you enable chassis
clustering, the control interface between the two devices (
created on this port.
You must also make another connection between the two devices for the fabric link.
You can use any Fast Ethernet or Gigabit Ethernet port for this connection. You must
configure the interface you choose as the fabric link. For more information on configuring
chassis clusters, see the
On the SRX210 Services Gateway, the
gateway is operating in chassis cluster mode.
The fxp0 port is dedicated as the out-of-band management interface for each of the
devices in the chassis cluster setup and the
control port.
Table 40 on page 127 shows the mapping of the chassis cluster ports.

Table 40: Mapping the Chassis Cluster Ports on an SRX210 Services

Gateway
Ethernet Ports on SRX210 Services Gateway
0/6 ( )
fe-0/0/6
0/7 ( )
fe-0/0/7
Junos OS automatically creates the fxp0 and fxp1 interfaces on these ports when the
SRX210 Services Gateway is operating in chassis cluster mode.
For more information, see the following guides:
Junos OS Interfaces and Routing Configuration Guide
Junos OS Security Configuration Guide
Telnet allows you to connect to the services gateway and access the CLI to execute
commands from a remote system. The Telnet CLI connections are not encrypted and
therefore can be intercepted.
fxp0 ) is automatically created on this port.
Junos OS Security Configuration Guide
port is not user-configurable when the services
fxp1
port is dedicated as the chassis-cluster
fxp1
Management Interface
fxp0 (management port)
fxp1 (control port)
Chapter 17: Configuring Basic Settings
) is automatically
fxp1
.
127