Gateway; Figure 24: Connecting The Srx210 Services Gateway To The Power Supply - Juniper SRX210 Series Manual

SRX210 Services Gateway Hardware
Related
Documentation
Connecting and Organizing Interface Cables for the SRX210 Services Gateway
106

Figure 24: Connecting the SRX210 Services Gateway to the Power Supply

NOTE: The device must be connected to earth ground during normal
operation. The protective earthing terminal on the rear of the chassis is
provided to connect the device to ground.
CAUTION: We recommend using a surge protector for the power connection.
NOTE: Use the cable tie holder to secure the power cord on to the power
supply point.
NOTE: We strongly recommend that you use only the 3-prong power cord
supplied with your services gateway. If you are using a 2-prong power cord,
then ensure that your device is adequately grounded using the grounding
point available on the back panel of the chassis.
Required Tools and Parts for Installing and Maintaining the SRX210 Services Gateway
on page 78
Grounding the SRX210 Services Gateway on page 108
Connecting and Organizing Interface Cables to the SRX210 Services Gateway on
page 106
SRX210 Services Gateway General Safety Guidelines and Warnings on page 47
You can connect the interfaces installed in the services gateway to various network
media. Each type of interface on the services gateway uses a particular medium to
Copyright © 2012, Juniper Networks, Inc.