Showing The Spo Pulse Rate; Adjusting The Spo Pulse Beep Volume; Selecting The Beat Source; Setting The Variable Beat Tone - GE CARESCAPE ONE User Manual

CARESCAPE ONE User Manual DRAFT 26 October 2017
SpO can be the Primary HR Source.
2
1. Select the SpO
2. Select Setup > Page 1.
3. Select the heart rate source from the Primary HR Source list.
Showing the SpO
1. Select the SpO
2. Select Setup > Page 1.
3. Select Show Pulse Rate.
Adjusting the SpO
1. Select the SpO
2. Select Setup > Page 2.
3. Adjust the volume with the Beat Volume selector.

Selecting the beat source

1. Select the SpO
2. Select Setup > Page 2.
3. Select the beat source from the Beat Source list.
The beat source indicator
and the beat sound will reflect the beat of that source.

Setting the variable beat tone

The SpO
When turned on, the heart rate beep pitch changes according to increasing and
decreasing SpO
tone, and lower values have a lower pitch.
1. Select the SpO
2. Select Setup > Page 2.
3. Select Variable Beat Tone Source > SpO2 or Off.
For more information, see the supplemental information provided.

Masimo SET data averaging and updating

For Masimo SET technology, when using the default averaging time of 8 seconds,
there is a maximum data-averaging signal processing time of 10 seconds from real
time plus an additional delay of 2 seconds to update the displayed waveform.
Selecting the SpO
NOTE
You can have an average of the SpO
how many seconds are used for this averaging. With Masimo SET technology, the
2094480-001
parameter window.
2
pulse rate
2
parameter window.
2
pulse beep volume
2
parameter window.
2
parameter window.
2
will appear beside the chosen beat source on the screen,
variable beat tone can be set to affect the pitch of the heart rate beep tone.
2
values. Higher SpO
2
parameter window.
2
averaging time
2
Masimo SET technology and Masimo sensors or GE TruSignal
technology and TruSignal sensors only.
CARESCAPE ONE
saturation values have a higher pitch beep
2
measurement on screen, and you can select
2
SpO₂
145