GE CARESCAPE ONE User Manual page 363

CARESCAPE ONE User Manual DRAFT 26 October 2017
Setting
Label Select the pressure
site label.
Scale mmHg Select the waveform
scale.
Hemo Sweep
Select the waveform
Speed
display sweep speed.
Display Format Select the pressure
values display format.
Select Monitor Setup > Main Setup > Parameter Setup > Page 1 > CVP 2 > Advanced to
adjust the Filter Hz setting for the current patient. The factory default setting is 12.
Select Monitor Setup > Main Setup > Parameter Setup > Page 1 > CVP 2 > Alarms to adjust
these settings for the current patient. The following table lists the factory default settings.
Setting
Mean alarm limits
Select the high/low
alarm limits.
Mean alarms Enable alarm when
on/off limits are violated.
UVC 2 pressure site default settings
The default P2 pressure site for the NICU software package is UVC. Select Monitor Setup >
Main Setup > Parameter Setup > Page 1 > UVC 2 > Setup > Page 1 or Page 2 to adjust these
settings for the current patient. The following table lists the factory default settings.
Setting
Label
Scale mmHg
Hemo Sweep Speed
Display Format
Select Monitor Setup > Main Setup > Parameter Setup > Page 1 > UVC 2 > Advanced to
adjust the Filter Hz setting for the current patient. The factory default setting is 12.
Select Monitor Setup > Main Setup > Parameter Setup > Page 1 > UVC 2 > Alarms to adjust
these settings for the current patient. The following table lists the factory default settings.
Setting
Mean alarm limits
Mean alarms on/off
2094480-001
ED
Description
ED
Description
Description
Select the pressure site label.
Select the waveform scale.
Select the waveform display sweep
speed.
Select the pressure values display
format.
Description
Select the high/low alarm limits.
Enable alarm when limits are violated.
CARESCAPE ONE
ICU OR
CVP
0-20
(Infant profile: 0-10)
25 mm/s
Mean only
ICU OR
15/0
(Infant profile: 10/0)
Enabled
NICU
UVC
0-10
25 mm/s
Mean only
NICU
5/0
(Infant profile: 10/0)
Enabled
Default settings
PACU
PACU
363