The Mode Change Command; The Reset Command - Xerox 4213 Programmer's Reference Manual

XES COMMAND LANGUAGE MODE
PostScript
HP PCL Emulation
2-2

The mode change command

The mode change command resets your 4213, enabling it to
accept printing commands in the desired emulation mode.
Note: Unpredictable results such as loss of data may occur if the
mode change command is not entered with valid parameters.
Send the following commands to your printer, preferably in the
form of a test file:
Emulation
=MCK=EMULATE/POSTSCRIPT/END L
This information tells your printer to begin printing in the
PostScript emulation mode.
=MCK=EMULATE/PCL/END L
This information tells your printer to begin printing in the HP PCL
emulation mode.
XES Emulation
=MCK=EMULATE/XDCS/END L
This information tells your printer to begin printing in the XES
emulation mode.
"2700" in the mode change command to enter the XES
emulation mode.
Note:
sequence. A line ending following the END keyword completes
the command.

The reset command

The reset command resets the 4213 laser printer, restoring it to
the default settings that were in effect at the last power off cycle.
Send the following command to your printer, preferably in the
form of a text file:
Reset
=MCK=RESET/END L
You can replace "XDCS" with either "XES" or
A space is required immediately after the =MCK=
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE