Load Translation Table - Xerox 4213 Programmer's Reference Manual

Where to place it

Load Translation Table

XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
At the start of the job.
Example To move the % symbol from its current hex location of 25H to a
new location at 7EH, enter:
E +T, L
E S40500FC2500FFX
The data record in this example is summarised below.
S
4
05
00FC2500
FF
XL
More The Reset command returns the printer to the default language.
Purpose Loads a special translation table for Laserpage software. This
command performs the same function as the E
does not cause a page eject.
Syntax
E zt
XES COMMAND LANGUAGE MODE
L
A data record always begins with the letter "S".
4 is used here. The use of other numbers excludes
certain fonts.
Use 05 as the byte count to move one character at
a time.
The data following the byte count consists of the
the hex values of the character or characters being
assigned.
Always put FF at the end of each record. To move
more characters, make additional records.
X and L together terminate table loading and
should be included after the FF in the last record.
command, but
+T
2-113