Top Offset Registration - Xerox 4213 Programmer's Reference Manual

LJ SERIES 2D EMULATION

Top Offset Registration

2-sided Page Side Selection
3-16
Purpose This command designates the position of the logical page across
the length (long side) of the physical page.
Syntax
E
&l#Z
Hex 1B 26 6C # 5A
Dec 27 38 108 # 90
where #
decipoints (1/720th inch) and valid up to four decimal places. A
positive value moves the logical page down along the length of
the physical page except on the back side of sheets printed in
horizontal-binding 2-sided mode, where the logical page moves
up. A negative value moves the logical page up, except on the
back side of sheets printed in horizontal-binding 2-sided mode,
where it moves down.
Notes Page orientation has no effect on this command.
•
The value # represents an absolute move in relation to the
•
default position of the logical page and not the current
position.
Positioning the logical page outside the printable area may
•
cause loss of data.
Purpose This command causes the printer to skip a page while printing in
2-sided. If a front or back page is being formatted while the
command is sent to the printer, the printer stops formatting,
ejects the current page, and prints on the side specified by the
value #.
Syntax
E
&a#G
where # = 0 selects the next side
# = 1 selects the front side
# = 2 selects the back side.
is a positive or negative number expressed in
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE