Tabs Vertical - Xerox 4213 Programmer's Reference Manual

XES COMMAND LANGUAGE MODE

Tabs Vertical

Where to place it
2-48
Purpose Defines tabs down the page, measuring from the top edge of the
page. Once vertical tabs are set, whenever you press the vertical
tab key on the host computer, the printer skips from the current
text position to the next vertical tab position.
Syntax
E
vn1,n2,.....,n125
v
n1,n2,..,n125
L Line end.
At the start of the job, or anywhere a vertical tab is desired.
Example Figures 2-9 and 2-10 show a line of tabs down an 216 x 279 mm
landscape page. Figure 2-9 shows the settings in units of five
pixels (1/60 inches). Figure 2-10 shows the same settings in units
of one pixel (1/300 inches).
More Up to 125 vertical tabs may be set per job. If you attempt to tab
past the bottom margin, the printer will skip to the top margin of
the following page.
L
Instruction to set vertical tabs
Tab settings starting from the top edge. Up to 125
tabs can be set in one command. Commas
separate values. The positions of the first tab and
tab intervals for U.S. and international paper, both
landscape and portrait, appears in table 2-5.
The printer maintains up to 125 vertical tabs in
memory per job. See table 2-6 for maximum tab
values for portrait and landscape pages in letter
and legal size.
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE