Xerox 4213 Programmer's Reference Manual page 99

Where to place it
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
Syntax
E
rDnc
The instruction for relative placement
r
A character indicating the direction from the current
D
text position in which the text is to be placed:
u
d
l
r
The distance in pixels (or 1/300th inch) from the
n
current text position to the new text position.
Any non-numeric character can be used to complete
c
this command.
Note: This is one of a few commands using a printable character
rather than a line end for completion. Do not use a line end.
Immediately after the current text (that is, the text being used as
a point of reference) and immediately before the text to be
affected.
More For both landscape and portrait pages, it is possible to print text
off the left edge of the page. For example, entering E
not cause an error. However, any text after the command and
before a line end will print off the page.
Example To place text 75 pixels to the left of the current position, enter
(Current text)E
As shown in figure 2-13, the final word of a sentence is placed
1500 pixels down from the current text position.
XES COMMAND LANGUAGE MODE
Up
Down
Left
Right
rl75e(New text)
will
rl3000b
2-61