INTERFACES
Dataproducts connector
1-8
4. Press the Test B button.
5. Press the Last Page C button until PARALLEL DPROD appears.
6. Press the Select D button to select Dataproducts parallel.
The use of a pigtail conversion cable provides compatibility with
the Dataproducts 2260 line printer controllers. The Dataproducts
interface uses a 50-pin Winchester connector # MRA S D5J,
which mates with a Winchester MRAC 50 P JKTCH connector,
using 100 1020P pins. The pin names are provided in this figure
only for the sake of information. They do not appear on the real
connector.
The
maximum
Dataproducts interface is 10 feet (3.05 metres). Figure 1-3 shows
the Dataproducts connector.
The
4213
does
not
Dataproducts 2260.
Figure 1-3.
Dataproducts interface connector
XEROX 4213 LASER PRINTER PROGRAMMER REFERENCE
cable
length
when
support
Negative
Logic
using
the
mode
for